What is happening? Build a setup with a few deep storage units(DSU) as an external storage. Plug an export bus on top and a storage bus from the side. From the theory, it should be exporting all the stuff from ME system to the DSU, and still be wisible from the ME. But it only export 1 stack of the item and wouldn't go forward until I set Storage bus to insert only or remove it complitly. When I put it back, it works, but when I input another stack of desired item into ME, it stays there, and wouldn't go into the DSU. What is expected?: Repair How to reproduce?: See abowe Server or Single Player?: Single player Screenshot?: 1: http://s008.radikal.ru/i306/1409/05/f112850d108d.png 2: http://s010.radikal.ru/i314/1409/00/e0467a7ca14d.png Crash Log?: None

I think this is by design. You can use 2 networks to prevent the looping of items, you can also skip the export busses, and instead use an IO Port to move items from your drives to the storage busses on the DSUs

No. That's would just do it once. I mean I want it to be in the system, but in external storage. For example, I toss some cobblestone in the ME Terminal, and there are the DSU that have all my cobblestone, it autamaticaly should go there thru extort bus, and be available from terminal. This way you can unload disk drives. That's the idea, and it should be possible, but not working.

storage bus export all item send in the network to their linked storage just like an export bus so you dont need it after moving all the items that where in the network before you install the storage bus :) (yep it dont export the item already in cell and in that case it will often use cell as a higher priority than the storage bus so you need to empty the cell of the items first or just remove them from the network temporaly and see the * below) i have 3 DSU connect to my network using storage bus only i can send and take from them wirthout problems from all my terminal. *on another note you can send the items into the storage bus using an io port, just configure you storage bus with the items you want in the dsu and place your cell in an io port it will extract all remaining items into the storage bus automatically :), when done replace all you storage cell and now if you add the items that are mean to go in the dsu in your network it will send them in the dsu normally. you dont really need 2 network too. if it dont work you messed something in your config of the storage bus or the me drive/chest (look for priority ;) )

Yes! It works! Thanks a lot! Didn't know it could be used like that!

Closing, cause resolved.